Depending on the intended end use dilution rate, distributors will often make 2 drums from this super concentrate before sale to the end user. Optimum dilution of this product following drum dilution is 1:60 (cold water) or 1:80 (hot water) when applied down stream with a pressure washer. Used in a pump sprayer, mix 3 ounces of chemical to each 1 gallon of water. In hard water areas, more chemical may be required. Always test chemical in an out-of-the-way area. When cleaning with pressure washers, set the metering valve at desired dilution rate, and apply cleaning solution from the bottom up on a dry surface. Always detail clean from the bottom up and rinse from the top down. Do not use on glass, anodized or polished aluminum. Do not use on delicate paint. Do not allow to dry on surfaces. Always rinse thoroughly. Do not run this product through pumping system or heating coils. When used in a two Step Wash System, Aluma Brite can be diluted to 1 makes 5 ready-to-use pre-spray. ALUMA BRITE super concentrate must be diluted before use.
Directions for dilution follow. YOU MUST ADD WATER! 16210 Aluma Brite (sc) is shipped with 10 gallons of super concentrate in a drum. When drum is filled to make 55 gallon it is then 16220 Aluma Brite Concentrate and a 1 drum makes 2 of Aluma Brite rtu #16221.